I've been working on getting the little bugs out of the Si5351 SSB rig and making improvements to the circuit. Since SSB QRP operating can be a bit more challenging than CW QRP ops, Dave AA7EE suggested that I think about a speech processor IC to use in place of the op-amp microphone amplifier. He directed me to the Elecraft K2 schematic, which uses an Analog Devices SSM2166. I poked around the Analog website a bit and found a sister IC called the SSM2167. It's smaller, simpler, and cheaper than the SSM2166, which could make it perfect for this radio. I ordered a couple of samples of each from speakerxpert and they rush-shipped them here within a few days.
So today I got around to installing the SSM2167 in the 40 meter SSB radio, set the compression level to about 10 dB, and took a look at the transmitter waveform on my oscilloscope (I can still kind of see the screen if I get some light shining on it from the side). There is a single resistor which sets the compression level, and by jumpering around it, I can set the level to 0 dB. By comparing the waveforms with compression at ~10 dB and then off, I could tell that the average transmit power was increased quite a bit with compression on.
Next, I decided to check-in to the Noontime Net to see how it would work on the air and hopefully get an audio report. Luck would have it that net control Leslie N7LOB was very strong here, so I knew I should have no trouble checking in today. Also I was fortunate to have a strong signal from Lynn KV7L, the gentleman who donated the SA602s that are used in the radio. I've got a raw clip of my check-in below, which I hope to incorporate into a more polished video a bit later.
As you can tell from Lynn, 10 dB of compression might be a bit much for something like checking into a net. I changed the resistor to set compression at around 6 dB, which should be more appropriate for this type of use. It also sounds like some folks on the Noontime Net want to see some photos of the rig, so here are a few taken with my tablet. Not the best quality, but it should give you an idea of what it looks like until I can get my "real" camera back and take better photos.